Refrigerators and freezers
A fridge that runs but will not cool usually starts with the condenser coils. In apartments, those coils hide underneath or behind the toe grille, matted with dust and pet hair that force the compressor to overwork. Next the tech listens for the evaporator fan behind the freezer panel, because a dead fan leaves a freezer cold and the fresh food side warm. If frost has built up on the evaporator coil, the defrost system is next: heater, defrost thermostat and control board, each checked for continuity with a multimeter. Repeated clicking with no compressor hum often means the start relay or overload has failed.
Washers
A washer full of standing water almost always comes down to the drain path. The tech checks the pump filter for socks, coins and hair ties, then tests the drain pump motor itself. A machine that refuses to start or spin often has a failed lid switch on a top-loader or a bad door lock assembly on a front-loader. Loud banging during spin points to the suspension: worn shock absorbers, springs or a cracked spider arm on the drum.
Dryers
No heat in an electric dryer usually means a blown thermal fuse or a burned-out heating element, and no heat in a gas dryer often means a weak igniter or failed gas valve coils. A drum that sits still suggests a broken belt, while squealing or thumping points to worn drum rollers or the idler pulley. Here is the part people skip: a thermal fuse blows for a reason, and that reason is usually a clogged vent. In high-rise buildings with long vent runs, a good tech checks airflow at the exhaust before closing out the job.
Dishwashers
Water pooling in the tub starts with a check of the filter and drain hose, then the drain pump. If the unit hums but never fills, the water inlet valve and its solenoid get tested. Dishes coming out wet and cold suggest a failed heating element or high-limit thermostat.
Ranges, ovens and cooktops
A gas oven that clicks but will not light usually has a weak hot surface igniter that no longer pulls enough current to open the safety valve. The tech checks that with a clamp meter, and may use a manometer to confirm gas pressure at the regulator. Electric ovens that heat unevenly often have a broken bake or broil element, and ovens that run hot or cold usually have a drifting temperature sensor, checked against the resistance chart on the tech sheet.
Microwaves
If the light and turntable work but food stays cold, the magnetron, high-voltage diode or capacitor may be at fault. A totally dead microwave often has a blown internal fuse triggered by a bad door switch. Do not open a microwave on your own, because the high-voltage capacitor can hold a lethal charge long after unplugging, and a trained tech discharges it safely before any work begins.